Switching on and off frequently, you are murdering your air conditioner

Switching on and off frequently, you are murdering your air conditioner

In summer, it is inevitable to turn on and off the air conditioner. If it feels cold, you have to turn off the air conditioner. When the temperature in the room becomes hot, you have to turn on the air conditioner. But do you guys know? Frequent switching of the air conditioner is actually "murdering" your air conditioner.

　　 Today, the editor of okmarts.com will bring you the important rules that need to be paid attention to when the air conditioner is in use. If you have an air conditioner at home, you must not miss it.

　　* The air conditioner should not be switched on and off frequently.

　　 Do not start and close the air conditioner frequently because the room temperature has reached the required value or is higher than the required value. Instead, the air conditioner should be controlled by the temperature controller to start and close.

　　 Switch on and off frequently. You are "murdering" your air conditioner.

　　* The air conditioner shuts down for any reason (such as sudden power failure, manual shutdown, etc.).

　　 Since general air conditioners are equipped with a shutdown time delay (the delay time is about 3 minutes), this type of air conditioner can be turned on immediately after shutting down, but it takes 3 minutes before it can operate. But for the air conditioner without time delay, it cannot be turned on immediately after shutdown. It must be about 3 minutes before the air conditioner can be turned on again, otherwise it may cause excessive starting current, burn the fuse, or even burn the compressor motor.

　　* Taking refrigeration conditions as an example, after the air conditioner is turned on and running, the following two situations may occur:

　　 One is that the air conditioner compressor starts and stops frequently, and the indoor temperature cannot drop;

　　 The second is that the indoor temperature is too low, and the air conditioner compressor does not stop running. It may be that the temperature setting of the temperature regulator is incorrect (too high or too low). The temperature setting value should be adjusted appropriately to make the indoor temperature reach the required value, so as to avoid frequent start and stop of the air conditioner compressor or excessive room temperature deviation.

　　* After starting up and running, the cooling (heating) capacity of the air conditioner can be adjusted by adjusting the air volume switch as needed.

　　The cooling (heating) volume of general air conditioners is adjusted by changing the air volume to achieve the purpose of regulation (inverter air conditioners adjust the compressor speed). Window air conditioners are generally equipped with strong cold and weak cold or strong heat and weak heat knobs. The knob is set to strong cold (hot) or weak cold (hot), which actually adjusts the air volume to high or low air volume. The remote control used by split-type air conditioners is generally equipped with high, medium and low wind speeds for selection. According to the indoor temperature requirements, the wind speed of the air conditioner can be adjusted to achieve the purpose of adjusting cooling or heating.

Switching on and off frequently, you are "murdering" your air conditioner

　　 Whether it is a manual switch or remote control operation, the operation of the air conditioner is basically as follows:

　　*According to the air conditioning requirements and use requirements, select the operation mode of the air conditioning, such as refrigeration, heating, dehumidification or ventilation. Just press the operating mode selection button on the air conditioner to select.

　　*Set the temperature and adjust the temperature value of the temperature regulator. In general cooling operation, the temperature setting range is 20 to 30°C. During heating operation, the temperature value setting range is 14 to 27°C, and the temperature value set refers to the return air temperature of the air conditioner or the room temperature. In order to check whether the compressor can operate, the set value should be lower than the current indoor temperature during cooling and higher than the current indoor temperature during heating. After the air conditioner is turned on, it can be judged whether the compressor can operate normally.

　　* After completing the above operations, turn on the air conditioner, and the air conditioner can operate normally according to the selected operating mode.