16 important factors that must be considered for cold storage installation

16 important factors that must be considered for cold storage installation

When installing the cold storage, the most important thing is to be able to do our most basic things well, and to be able to put ourselves in the position for the sake of our customers. So what exactly do cold storage installations do? Let's take a look!

　　 1. The cold storage is installed in a strong and stable place.

　　2. The cold storage is installed in a place with good ventilation and low humidity, and the cold storage is installed in a place protected from light and rain.

　　3. The drainage in the cold storage is discharged through a drainage pipe. Water is often drained, so direct the drain to a place where it can circulate smoothly.

　　 4. The installation of the combined cold storage requires a horizontal concrete base. When the foundation is inclined and uneven, the foundation must be repaired and leveled.

　　5. The partition wall of the combined cold storage shall be fixed with the partition angle steel.

　　6. ​​After the combined cold storage body is installed, check the fit of each board seam. If necessary, the inside and outside should be filled with silica gel to seal.

　　 7. The combined cold storage is used inside the house. When installed outside the house, a house cover should be installed to block sunlight and rain.

　　 8. The U-shaped pipe is not installed on the drain pipe, which sometimes causes the unit to be corroded.

　　9. When the cold storage is in a hot place, not only the cooling efficiency will be reduced, but the storage board will sometimes be damaged. In addition, the ambient temperature to ensure the normal operation of the unit is within 35 degrees. Also leave room for overhaul of the unit.

　　10. When putting together the board, pay attention to sticking the sponge tape on the convex edge of the warehouse board completely, and avoid collision when installing the cold storage board. The sponge tape sticking position.

　　11. U-shaped pipes must be installed on the drainage pipes. U-shaped pipes can prevent air-conditioning from leaking, insects, and mice.

　　12. Due to the wide variety of cold storage panels, please refer to the "Assembly Schematic Diagram of Cold Storage" when installing mobile cold storage.

　　13. When tightening the hook, apply force slowly and evenly until the board is closed. Do not use excessive force to prevent the hook box from pulling out.

　　14. The cold storage should leave heating appliances.

　　 15. After the pipeline and electrical installation are completed, all pipelines on the combined cold storage board are perforated and must be sealed with waterproof silica gel.

　　 16. After the cold storage is installed, sometimes condensation will appear before the concrete base is dry. When the humidity is abnormally high such as the rainy season, condensation will appear on the joints of the slab, and in very small cases, condensation will also appear on the refurbished slab.